The part is not ret received so the following is theory.  The apparent reason for breakage is due to slight shifting during installation of the new thermostat from its intended very shallow counter bore onto the flat surface reserved for the mating housing.  This causes the thermostat outer radius to create a high spot (should be flat when nestled properly) onto which the housing is torqued, snapping the casting. I intend to lock the thermostat into its C-bore with a thin coating of liquid gasket before mating and torque of the housing.

Hello all, I have a rather unusual problem with my 2011 Juke (diseal).

Around 10 miles or so after filling up the tank, the engine developes a stutter like it is runningout of fuel. It then clears after 6 miles or so and runs smooth again until the half tank mark when it repeats the problem. 

Has anyone else ever had this issue or have any idea what it could be ? 

Any suggestions would be most gratefully received.

Mike.

Hi There, Im the proud owner of a 2011 Qashqai+2 1.5dc1 (definitely built for comfort and economy) I joined the forum in the hope of getting some assistance with a few things. I have asked questions about on the internet in general but with no success. My Radio CD a factory fitted 28185BH30D, is afflicted with the seemingly common and expensive problem of the screen only working in temperatures around zero degrees. Replacement Screen - Expensive, replacement like for like unit eye wateringly expensive

To save money i was wondering if I can replace it with a much cheaper second hand 28185JD05A or similar.  Does anyone have any advice for me on the matter please?

Pegards

I have had a few Almera's and really enjoyed driving them, i need some help with a Qashqai problem which i will post on the hopefully correct section.